Embertec Emberplug EPUSAV-ET-01 Guía de instalación descargar pdf (Pagina 9)

We recommend connecting any home theater media center computers,

or appliances containing a hard drive into the ‘Always On’ socket. We

recommend connecting home theater projection equipment which require

a cool down period to the 'Always On' socket. This will prevent damage to,

and extend the life of your home theater projection lamps.

The Embertec Emberplug™ AV has 2 power

saving functions

1. Standby Powerdown automatically detects and saves power wasted

when equipment is left in standby mode, by switching the power o to

the equipment.

2. Active Powerdown automatically switches the power o to Audio Visual

(AV) equipment connected to the 'Power Saver' socket after 1 hour, if it

has not detected any remote control use.

NOTE: The Embertec Emberplug™ AV is programmable and has an Active

Powerdown default setting of 1 hour, which can be permanently set to

2 or 3 hours, or temporarily 8 hours (MusicMode™).

When will Active Powerdown Switch the Audio

Visual (AV) Equipment o?

If your Embertec Emberplug™ AV detects that your Audio Visual (AV) •

equipment is on but has not been used for a period of 1, 2, 3 or 8 hours

(depending on your settings), the LED light on the SmartSensor will ash

for approximately 10 minutes to warn you that power down is imminent.

To continue using your equipment.

Simply press ANY button on ANY of your existing remote controls or press •

the button on the SmartSensor once. This will cancel the Active Powerdown

and reset the timer to 1, 2, 3 or 8 hours (according to your setting).

NOTE: A ashing LED always means that your system will shut down

completely in a while. Press any remote control button to stop the light

ashing and continue using your system.

Press button on

the SmartSensor.

A ashing light means

the system is getting

ready to shut down.

TO CONTINUE

USING YOUR

EQUIPMENT

Press any remote

control button

Vol

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

Embertec Emberplug EPUSAV-ET-01 Guía de instalación Pagina 9